Port Security Commands - NETGEAR ProSafe M7100-24X User Manual

Field Description
Last Querier Indicates the IP address of the most recent Querier from which a Query was received.
Address
Last Querier Indicates the MLD version of the most recent Querier from which a Query was received
Version on this VLAN.
When the optional argument detail is used, the command shows the global information
and the information for all Querier-enabled VLANs.

Port Security Commands

This section describes the commands you use to configure Port Security on the switch. Port
security, which is also known as port MAC locking, allows you to secure the network by
locking allowable MAC addresses on a port. Packets with a matching source MAC address
are forwarded normally, and all other packets are discarded.
Note: To enable the SNMP trap specific to port security, see
enable traps violation
port-security
This command enables port locking at the system level (Global Config) or port level (Interface
.
Config)
Default
disabled
Format
port-security
Mode
• Global Config
• Interface Config
no port-security
This command disables port locking for one (Interface Config) or all (Global Config) ports.
Format
no port-security
Mode
• Global Config
• Interface Config
ProSafe Managed Switch
on page 664.
Switching Commands
168
snmp-server