Ipv6 Mld-Proxy Commands - NETGEAR ProSafe M7100-24X User Manual

Field
Valid MLD Packets Received The number of valid MLD packets received by the router.
Valid MLD Packets Sent
Queries Received
Queries Sent
Reports Received
Reports Sent
Leaves Received
Leaves Sent
Bad Checksum MLD Packets The number of bad checksum MLD packets received by the router.
Malformed MLD Packets

IPv6 MLD-Proxy Commands

MLD-Proxy is the IPv6 equivalent of IGMP-Proxy. MLD-Proxy commands allow you to
configure the network device as well as to view device settings and statistics using either
serial interface or telnet session. The operation of MLD-Proxy commands is the same as for
IGMP-Proxy: MLD is for IPv6 and IGMP is for IPv4.MGMD is a term used to refer to both
IGMP and MLD.
ipv6 mld-proxy
Use this command to enable MLD-Proxy on the router. To enable MLD-Proxy on the router,
you must enable multicast forwarding. Also, make sure that there are no other multicast
routing protocols enabled n the router.
Format
ipv6 mld-proxy
Mode
Interface Config
no ipv6 mld-proxy
Use this command to disable MLD-Proxy on the router.
Format
no ipv6 mld-proxy
Mode
Interface Config
ProSafe Managed Switch
Description
The number of valid MLD packets sent by the router.
The number of valid MLD queries received by the router.
The number of valid MLD queries sent by the router.
The number of valid MLD reports received by the router.
The number of valid MLD reports sent by the router.
The number of valid MLD leaves received by the router.
The number of valid MLD leaves sent by the router.
The number of malformed MLD packets received by the router.
IPv6 Multicast Commands
433