Ipv6 Enable; Ipv6 Unicast-Routing - NETGEAR ProSafe M7100-24X User Manual

advertisements and a value of 64 is sent in packets originated by the node. Note that this is
not the same as configuring a value of 64.
Default
not configured
Format
ipv6 hop-limit <hops>
Mode
Global Config
no ipv6 hop-limit
This command returns the unicast hop count to the default.
Format
no ipv6 hop-limit
Mode
Global Config

ipv6 unicast-routing

Use this command to enable the forwarding of IPv6 unicast datagrams.
Default
disabled
Format
ipv6 unicast-routing
Mode
Global Config
no ipv6 unicast-routing
Use this command to disable the forwarding of IPv6 unicast datagrams.
Format
no ipv6 unicast-routing
Mode
Global Config

ipv6 enable

Use this command to enable IPv6 routing on an interface, including tunnel and loopback
interfaces, that has not been configured with an explicit IPv6 address. When you use this
command, the interface is automatically configured with a link-local address. You do not need
to use this command if you configured an IPv6 global address on the interface.
Default
disabled
Format
ipv6 enable
Mode
Interface Config
ProSafe Managed Switch
IPv6 Commands
354