lldp med
Use this command to enable MED. By enabling MED, you will be effectively enabling the
transmit and receive function of LLDP.
Default
enabled
Format
lldp med
Mode
Interface Config
no lldp med
Use this command to disable MED.
Format
no lldp med
Mode
Interface Config
lldp med confignotification
Use this command to configure all the ports to send the topology change notification.
Default
enabled
Format
lldp med confignotification
Mode
Interface Config
no ldp med confignotification
Use this command to disable notifications.
Format
no lldp med confignotification
Mode
Interface Config
lldp med transmit-tlv
Use this command to specify which optional Type Length Values (TLVs) in the LLDP MED set
will be transmitted in the Link Layer Discovery Protocol Data Units (LLDPDUs).
Default
By default, the capabilities and network policy TLVs are included.
Format
lldp med transmit-tlv [capabilities] [ex-pd] [ex-pse] [inventory]
[location] [network-policy]
Mode
Interface Config
Term
Definition
capabilities
Transmit the LLDP capabilities TLV.
ex-pd
Transmit the LLDP extended PD TLV.
ProSafe Managed Switch
Switching Commands
181