Telnet Commands; Enable Authentication; Show Serial - NETGEAR ProSafe M7100-24X User Manual

enable authentication

Use this command in line configuration mode to specify an authentication method list when
the user accesses a higher privilege level in remote telnet or console.
Format
enable authentication {default | list-name}
Mode
Line Config
no enable authentication
Use this command to return to the default specified by the
command.
Format
no enable authentication {default | list-name}
Mode
Line Config

show serial

Use this command to display serial communication settings for the switch.
Format
show serial
Modes
• Privileged EXEC
• User EXEC
Term Definition
Serial Port
The time, in minutes, of inactivity on a Serial port connection, after which the Switch will
Login Timeout
close the connection. Any numeric value between 0 and 160 is allowed, the factory
(minutes)
default is 5. A value of 0 disables the timeout.
Baud Rate (bps)
The default baud rate at which the serial port will try to connect. The available values are
1200, 2400, 4800, 9600, 19200, 38400,57600, and 115200 baud. The factory default is
9600 baud.
Character Size
The number of bits in a character. The number of bits is always 8.
(bits)
Flow Control
Whether Hardware Flow-Control is enabled or disabled. Hardware Flow Control is
always disabled.
Stop Bits
The number of Stop bits per character. The number of Stop bits is always 1.
Parity Type
The Parity Method used on the Serial Port. The Parity Method is always None.

Telnet Commands

This section describes the commands you use to configure and view Telnet settings. You can
use Telnet to manage the device from a remote management host.
ProSafe Managed Switch
Management Commands
621
enable authentication