Iscsi Aging Time - NETGEAR ProSafe M7100-24X User Manual

setting for egress queues scheduling is Weighted Round Robin
(WRR).
The user may complete the QoS setting by configuring the relevant
ports to work in other scheduling and queue management modes via
the Class of Service settings. Depending on the platform, these
choices may include strict priority for the queue used for iSCSI
traffic. The downside of strict priority is that, in certain circumstances
(under heavy high priority traffic), other lower priority traffic may get
starved. In WRR the queue to which the flow is assigned to can be
set to get the required percentage.
Format
iscsi cos traffic-class {vpt vpt | dscp dscp} [remark]
Mode
Global Config
Term Definition
traffic-class
The traffic class used for assigning iSCSI traffic to a queue.
vpt/dscp
The VLAN Priority Tag or DSCP to assign iSCSI session packets.
remark
Mark the iSCSI frames with the configured VPT/DSCP when egressing the switch.
no iscsi cos
This command is to set the quality of service profile of SCSI flows to default.
Format
no iscsi cos traffic-class {vpt vpt | dscp dscp} [remark]
Mode
Global Config

iscsi aging time

The iscsi aging time Global Configuration mode command sets aging time for iSCSI
sessions.
Behavior when changing aging time:
• When aging time is increased - Current sessions will be timed out according to the new
value.
• When aging time is decreased - Any sessions that have been dormant for a time
exceeding the new setting will be immediately deleted from the table. All other sessions
will continue to be monitored against the new time out value.
Format
iscsi aging time <time>
Mode
Global Config
Default
5 minutes
ProSafe Managed Switch
Quality of Service (QoS) Commands
493