No Monitor - NETGEAR ProSafe M7100-24X User Manual

specify the interface to receive the monitored traffic. Use the mode parameter to enabled the
administrative mode of the session. If enabled, the probe port monitors all the traffic received
and transmitted on the physical monitored port.
Format
monitor session <session-id> {source interface <unit/slot/port> [{rx
| tx}] | destination interface <unit/slot/port> | mode}
Mode
Global Config
no monitor session
Use this command without optional parameters to remove the monitor session (port
monitoring) designation from the source probe port, the destination monitored port and all
VLANs. Once the port is removed from the VLAN, you must manually add the port to any
desired VLANs. Use the source interface <unit/slot/port> parameter or
destination interface <unit/slot/port> to remove the specified interface from
the port monitoring session. Use the mode parameter to disable the administrative mode of
the session
Note: Since the current version of 7000 series software supports only one
session, if you do not supply optional parameters, the behavior of
this command is similar to the behavior of the no monitor
command.
Format
no monitor session <session-id> [{source interface <unit/slot/port>
| destination interface <unit/slot/port> | mode}]
Mode
Global Config

no monitor

This command removes all the source ports and a destination port for the and restores the
default value for mirroring session mode for all the configured sessions.
Note: This is a stand-alone "no" command. This command does not have
a "normal" form.
Default
enabled
Format
no monitor
Mode
Global Config
ProSafe Managed Switch
Switching Commands
120