Ip Ospf Dead-Interval; Ip Ospf Hello-Interval - NETGEAR ProSafe M7100-24X User Manual

no ip ospf database-filter all out
Use this command in Interface Configuration mode to enable OSPFv2 LSA flooding on an
interface.
Default
Disabled
Format
no ip ospf database-filter all out
Mode
Interface Configuration

ip ospf dead-interval

This command sets the OSPF dead interval for the specified interface. The value for
<seconds> is a valid positive integer, which represents the length of time in seconds that a
router's Hello packets have not been seen before its neighbor routers declare that the router
is down. The value for the length of time must be the same for all routers attached to a
common network. This value should be some multiple of the Hello Interval (i.e. 4). Valid
values range in seconds from 1 to 2147483647.
Default
40
Format
ip ospf dead-interval <seconds>
Mode
Interface Config
no ip ospf dead-interval
This command sets the default OSPF dead interval for the specified interface.
Format
no ip ospf dead-interval
Mode
Interface Config

ip ospf hello-interval

This command sets the OSPF hello interval for the specified interface. The value for seconds
is a valid positive integer, which represents the length of time in seconds. The value for the
length of time must be the same for all routers attached to a network. Valid values range from
1 to 65535.
Default
10
Format
ip ospf hello-interval <seconds>
Mode
Interface Config
ProSafe Managed Switch
Routing Commands
275