Ip Address Dhcp; Ip Default-Gateway - NETGEAR ProSafe M7100-24X User Manual

Mask of the interface. To remove all of the IP addresses (primary and secondary) configured
on the interface, enter the command no ip address.
Format
no ip address [{<ipaddr> <subnetmask> [secondary]}]
Mode
Interface Config

ip address dhcp

Use this command to enable the DHCPv4 client on an in-band interface so that it can acquire
network information, such as the IP address, subnet mask, and default gateway from a
network DHCP server. When DHCP is enabled on the interface, the system automatically
deletes all manually configured IPv4 addresses on the interface.
Default
disabled
Format
ip address dhcp
Mode
Interface Config
no ip address dhcp
Use this command to release a leased address and disable DHCPv4 on an interface.
Format
no ip address dhcp
Mode
Interface Config

ip default-gateway

Use this command to manually configure a default gateway for the switch. Only one default
gateway can be configured. If you use this command multiple times, each command replaces
the previous value.
Format
ip default-gateway <ipaddr>
Mode
Global Config
no ip default-gateway
Use this command to remove the default gateway address from the configuration.
Format
no ip default-gateway <ipaddr>
Mode
Interface Config
ProSafe Managed Switch
Routing Commands
225