Poe Priority; Poe Reset - NETGEAR ProSafe M7100-24X User Manual

Dynamic Power Management
Available power = 300 watts - 3 watts = 297 watts
Format
poe power management {<unit>|all} {dynamic | static}
Mode Global Config
Default dynamic
no poe power management
Use this command to set the power management mode to the default.
Format
no poe power management {<unit>|all}
Mode Global Config

poe priority

Use this command to configure the priority on a specific port. This is used for power management
purposes. The switch might not be able to supply power to all connected devices, so the port
priority is used to determine which ports will supply power if adequate power capacity is not
available for all enabled ports. For ports that have the same priority level, the lower numbered
port will have higher priority. There are three options:
• Crit—Critical priority
• High—High priority
• Low—Low priority
Format
poe priority { Crit | High | Low }
Mode Global Config
Interface Config
Default low
no poe priority
Use this command to set the priority to the default.
Format
no poe priority
Mode Global Config
Interface Config

poe reset

Use this command to reset the PoE state of every port (in global mode) or a specific port (in
interface mode). When the PoE port status is shown to be in an error state, this command can be
ProSafe Managed Switch
Power over Ethernet (PoE) Commands
500