NETGEAR ProSafe M7100-24X User Manual page 23

description
Use this command to create an alpha-numeric description of the port.
Format
description <description>
Mode
Interface Config
mtu
Use the mtu command to set the maximum transmission unit (MTU) size, in bytes, for frames
that ingress or egress the interface. You can use the mtu command to configure jumbo frame
support for physical and port-channel (LAG) interfaces. For the standard 7000 series
implementation, the MTU size is a valid integer between 1522 - 9216 for tagged packets and
a valid integer between 1518 - 9216 for untagged packets.
Note: To receive and process packets, the Ethernet MTU must include any
extra bytes that Layer-2 headers might require. To configure the IP
MTU size, which is the maximum size of the IP packet (IP Header +
IP payload), see
Default
1518 (untagged)
Format
mtu <1518-9216>
Mode
Interface Config
no mtu
This command sets the default MTU size (in bytes) for the interface.
Format
no mtu
Mode
Interface Config
shutdown
This command disables a port.
Note: You can use the shutdown command on physical and port-channel
(LAG) interfaces, but not on VLAN routing interfaces.
ProSafe Managed Switch
ip mtu on page 229.
Switching Commands
23