Radius Server Key - NETGEAR ProSafe M7100-24X User Manual

address or dns name of the previously configured RADIUS authentication / accounting
server.
Format
no radius server host {auth | acct} {<ipaddr|dnsname>}
Mode
Global Config
The following shows an example of the command.
(Switch) (Config) #radius server host acct 192.168.37.60
(Switch) (Config) #radius server host acct 192.168.37.60 port 1813
(Switch) (Config) #radius server host auth 192.168.37.60 name
Network1_RADIUS_Auth_Server port 1813
(Switch) (Config) #radius server host acct 192.168.37.60 name
Network2_RADIUS_Auth_Server
(Switch) (Config) #no radius server host acct 192.168.37.60

radius server key

Use this command to configure the key to be used in RADIUS client communication with the
specified server. Depending on whether the 'auth' or 'acct' token is used, the shared secret is
configured for the RADIUS authentication or RADIUS accounting server. The IP address or
hostname provided must match a previously configured server. When this command is
executed, the secret is prompted.
Text-based configuration supports Radius server's secrets in encrypted and non-encrypted
format. When you save the configuration, these secret keys are stored in encrypted format
only. If you want to enter the key in encrypted format, enter the key along with the encrypted
keyword. In the show running config command's display, these secret keys are displayed in
encrypted format. You cannot show these keys in plain text format.
Note: The secret must be an alphanumeric value not exceeding 16
characters.
Format
radius server key {auth | acct} {<ipaddr|dnsname>} encrypted
<password>
Mode
Global Config
Field Description
ipaddr
The IP address of the server.
dnsname
The DNS name of the server.
password
The password in encrypted format.
ProSafe Managed Switch
Management Commands
675