Show Lldp Med Remote-Device Detail - NETGEAR ProSafe M7100-24X User Manual

LLDP MED Remote Device Summary
Local
Interface Remote ID
--------- ---------
1/0/8 1
1/0/9 2
1/0/10 3
1/0/11 4
1/0/12 5

show lldp med remote-device detail

Use this command to display detailed information about remote devices that transmit current
LLDP MED data to an interface on the system.
Format
show lldp med remote-device detail <unit/slot/port>
Mode
Privileged EXEC
Term Definition
Supported
Shows the supported capabilities that were received in MED TLV on this port.
Capabilities
Enabled
Shows the enabled capabilities that were enabled in MED TLV on this port.
capabilities
Device Class
Shows the device class as advertized by the device remotely connected to the port.
Network Policy
Shows if network policy TLV is received in the LLDP frames on this port.
Information
Media
Shows the application type. Types of applications are unknown, voice, voicesignaling,
Application
guestvoice, guestvoicesignaling, sfotphonevoice, videoconferencing, streamingvideo,
Type
videosignaling.
VLAN Id
Shows the VLAN id associated with a particular policy type.
Priority
Shows the priority associated with a particular policy type.
DSCP
Shows the DSCP associated with a particular policy type.
Unknown
Indicates if the policy type is unknown. In this case, the VLAN id, Priority and DSCP are
ignored.
Tagged
Indicates if the policy type is using tagged or untagged VLAN.
Hardware
Shows the hardware version of the remote device.
Revision
Firmware
Shows the firmware version of the remote device.
Revision
Software
Shows the software version of the remote device.
Revision
ProSafe Managed Switch
Device Class
------------
Class I
Not Defined
Class II
Class III
Network Con
Switching Commands
188