show interface tunnel
This command displays the parameters related to tunnel such as tunnel mode, tunnel source
address and tunnel destination address.
Format
show interface tunnel [<tunnel-id>]
Mode
Privileged EXEC
If you do not specify a tunnel ID, the command shows the following information for each
configured tunnel:
Term
Definition
Tunnel ID
The tunnel identification number.
Interface
The name of the tunnel interface.
Tunnel Mode
The tunnel mode.
Source Address
The source transport address of the tunnel.
Destination
The destination transport address of the tunnel.
Address
If you specify a tunnel ID, the command shows the following information for the tunnel:
Term
Definition
Interface Link
Shows whether the link is up or down.
Status
MTU Size
The maximum transmission unit for packets on the interface.
IPv6 Prefix is
If you enable IPv6 on the interface and assign an address, the IPv6 address and prefix
display.
IPv6 Routing Commands
This section describes the IPv6 commands you use to configure IPv6 on the system and on
the interfaces. This section also describes IPv6 management commands and show
commands.
ipv6 hop-limit
This command defines the unicast hop count used in ipv6 packets originated by the node.
The value is also included in router advertisements. Valid values for <hops> are 1-255
inclusive. The default "not configured" means that a value of zero is sent in router
ProSafe Managed Switch
IPv6 Commands
353