Show Poe Port Configuration - NETGEAR ProSafe M7100-24X User Manual

Example:
(switch) #show poe
Firmware Version............................... 1.0.0.2
PSE Main Operational Status.................... ON
Total Power (Main AC).......................... 380
Total Power (RPS).............................. 300
Total Power (PD) .............................. 25
Power Source................................... Main AC
Threshold Power................................ 342
Total Power Consumed........................... 7
Usage Threshold................................ 90
Power Management Mode.......................... Dynamic
Configure port Auto Reset Mode................. Disable
Traps.......................................... Enable

show poe port configuration

Use this command to see how the PoE ports are configured. You can display information based
on each individual port or all the ports collectively.
Format
show poe port configuration [<port> |All]
Mode Privileged EXEC
User EXEC
(Switch) #show poe port configuration all
Admin
Intf Mode Priority
------ ------- -------- ------ -------------- ------------- ---------------------
1/0/1 Enable Low
1/0/2 Enable Low
(Switch) #show poe port configuration 1/0/2
Admin
Intf Mode Priority
------ ------- -------- ------ -------------- ------------- ---------------------
1/0/2 Enable Low
ProSafe Managed Switch
Power Power Limit
Limit Type
(W)
15.400 User Defined
15.400 User Defined
Power Power Limit
Limit Type
(W)
15.400 User Defined
Power over Ethernet (PoE) Commands
504
High Power
Mode
Disable Auto
Disable Auto
High Power
Mode
Disable Auto
Detection
Type
Detection
Type