Show Iscsi; Show Iscsi Sessions - NETGEAR ProSafe M7100-24X User Manual

Term Definition
time
The number in minutes a session is not active prior to it's removal. (Range: 1-43,200)
no iscsi aging time
This command is to reset the aging time to the default.
Format
no iscsi aging time
Mode
Global Config

show iscsi

This command displays the iSCSI settings.
Format
show iscsi
Mode
• Privileged EXEC
• User EXEC
Example:
The following example displays the iSCSI settings.
Console # show iscsi
iSCSI enabled
iSCSI vpt is 5, remark
Session aging time: 60 min
Maximum number of sessions is 256
-----------------------------------------------------------
iSCSI targets and TCP ports:
---------------------------
TCP Port Target IP Address
860
3260
5000
30001 172.16.1.1
30033 172.16.1.10
30033 172.16.1.25

show iscsi sessions

The show iscsi sessions Privileged EXEC mode command displays the iSCSI sessions.
Format
show iscsi sessions [detailed]
Mode
• Privileged EXEC
• User EXEC
Default
If not specified, sessions are displayed in short mode (not detailed)
ProSafe Managed Switch
Name
iqn.1993-11.com.disk-vendor:diskarrays.sn.45678.tape:sys1.xyz
Quality of Service (QoS) Commands
494