Show Ipv6 Interface - NETGEAR ProSafe M7100-24X User Manual

show ipv6 interface

Use this command to show the usability status of IPv6 interfaces and whether ICMPv6
Destination Unreachable messages may be sent.
Format
show ipv6 interface {brief | <unit/slot/port> |tunnel <0-7> |
loopback <0-7>}
Mode
Privileged EXEC
If you use the brief parameter, the following information displays for all configured IPv6
interfaces:
Term Definition
Interface
The interface in unit/slot/port format.
IPv6 Routing
Shows whether the mode is enabled or disabled.
Operational
Mode
IPv6
Shows the IPv6 address and length on interfaces with IPv6 enabled.
Address/Length
If you specify an interface, the following information also appears.
Term Definition
IPv6 is enabled
Appears if IPv6 is enabled on the interface.
Routing Mode
Shows whether IPv6 routing is enabled or disabled.
Administrative
Shows whether the interface administrative mode is enabled or disabled.
Mode
Bandwidth
Shows bandwidth of the interface.
Interface
The MTU size, in bytes.
Maximum
Transmission
Unit
Router
The number of consecutive duplicate address detection probes to transmit.
Duplicate
Address
Detection
Transmits
Router
The interval, in milliseconds, between router advertisements for advertised neighbor
Advertisement
solicitations.
NS Interval
Router
Shows the router lifetime value of the interface in router advertisements.
Advertisement
Lifetime
Router
The amount of time, in milliseconds, to consider a neighbor reachable after neighbor
Advertisement
discovery confirmation.
Reachable Time
ProSafe Managed Switch
IPv6 Commands
364