Deny (Management) - Planet Networking & Communication WGSD-1022 User Manual

Console (config)# management access-list mlist
Console (config-macl)# permit

5.13.3 deny (management)

The deny management access-list configuration command defines a deny rule.
Syntax
deny [ethernet interface-number | vlan vlan-id | port-channel number ] [service service]
deny ip-source ip-address [mask mask | prefix-length] [ethernet interface-number | vlan vlan-id |
port-channel number | out-of-band-eth oob-interface] ] [service service]
ethernet interface-number — A valid Ethernet port number.
vlan vlan-id — A valid VLAN number.
port-channel number — A valid port-channel number.
ip-address — Source IP address. (Range: Valid IP Address)
mask mask — Specifies the network mask of the source IP address.(Range: Valid subnet mask)
mask prefix-length — Specifies the number of bits that comprise the source IP address prefix.
The prefix length must be preceded by a forward slash (/).
service service — Indicates service type. Can be one of the following: telnet, ssh, http, https or
snmp.
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
User Guidelines
Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP address is defined on the
appropriate interface.The system supports up to 256 management access rules.
Example
The following example shows how all ports are denied in the access-list called "mlist".
Console (config)# management access-list mlist
Console (config-macl)# deny