Show Dot1X Advanced - Planet Networking & Communication WGSD-1022 User Manual

trap seconds — Send SNMP traps, and specifies the minimum time between consecutive
traps.(Range: 1- 1000000)
Default Configuration
Discard frames with source addresses not the supplicant address. No traps.
Command Mode
Interface configuration (Ethernet) mode
User Guidelines
The command is relevant when Multiple hosts is disabled and the user has been successfully
authenticated
Examples
The following example uses the forward action to forward frames with source addresses.
console config-if(Config-VLAN)# dot1x single-host-violation forward trap 100

5.29.18 show dot1x advanced

The show dot1x advanced privileged EXEC command displays 802.1X advanced features for the
switch or for the specified interface.
Syntax
show dot1x advanced [ethernet interface]
interface — Ethernet interface
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Examples
The following example displays 802.1X advanced features for the switch.
Switch# show dot1x advanced
Guest VLAN: 3978
Unauthenticated VLANs: 91, 92