Show Dot1X - Planet Networking & Communication WGSD-1022 User Manual

seconds — Time in seconds that the switch should wait for a response from the authentication
server before resending the request. (Range: 1 - 65535 seconds)
Default Configuration
30
Command Mode
Interface configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Examples
The following example sets the time for the retransmission of packets to the authentication server, to
3600 seconds.
console config-if(Config-VLAN)# dot1x timeout supp-timeout 3600

5.29.12 show dot1x

The show dot1x privileged EXEC command displays 802.1X status for the switch or for the specified
interface.
Syntax
show dot1x [ethernet interface]
interface —The full syntax is: unit/port.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Examples
The following example displays 802.1X status for the switch.
console# show dot1x
802.1x is disabled