Rmon Table-Size; Snmp Commands; Snmp-Server Community - Planet Networking & Communication WGSD-1022 User Manual

5.19.11 rmon table-size

The rmon table-size global configuration command configures the maximum RMON tables sizes. To
return to the default configuration, use the no form of this command.
Syntax
rmon table-size {history entries | log entries}
no rmon table-size {history | log}
history entries — Maximum number of history table entries. (Range: 20 - 32767)
log entries — Maximum number of log table entries. (Range: 20 - 32767)
Default Configuration
History table size is 270.
Log table size is 100.
Command Mode
Global Configuration mode
User Guidelines
The configured table size is effective after the device is rebooted.
Example
The following example configures the maximum RMON history table sizes to 1000 entries.
Console (config)# rmon table-size history 1000

5.20 SNMP Commands

5.20.1 snmp-server community

The snmp-server community global configuration command sets up the community access string to
permit access to the SNMP protocol. To remove the specified community string, use the no form of this
command.
Syntax
snmp-server community community [ro | rw | su] [ip-address]
snmp-server community-group community group-name [ip-address]
no snmp-server community string [ip-address]
community — Character string that acts like a password and permits access to the SNMP
protocol. (Range: 1 - 20 characters)
ro — Specifies read-only access.