Planet Networking & Communication WGSD-1022 User Manual page 40

• Current Port Speed The current speed of the port is displayed here
• Auto Negotiation
• Auto Negotiation
Advertisement
• Back Pressure
• Flow Control
• MDI/ MDIX
• PVE
Click the Save button to save your changes.
You can enable or disable the port's Auto Negotiation feature. If using
an SFP module, Auto Negotiation for the specific port should be set to
disable
Specifies the capabilities to be advertised by the port. Multiple options
may be selected or Max Capability can be selected to cover all of the
options.
The available options are:
All, which indicates that the port speeds and duplex mode settings
can be accepted.
10 Half, indicates that the port is advertising a 10Mbps half duplex
mode setting.
10 Full, indicates that the port is advertising a 10Mbps full duplex
mode setting.
100 Half, indicates that the port is advertising a 100Mbps half
duplex mode setting.
100 Full, indicates that the port is advertising a 100Mbps full duplex
mode setting.
1000 Full, indicates that the port is advertising a 1000Mbps full
duplex mode setting
The Back Pressure feature of the selected port can be enabled or
disabled
The Flow Control feature of the selected port can be enabled or
disabled
• Auto - the port to automatically detect the cable type.
• MDI - if the port is connected to an end station.
• MDIX - if the port is connected to a hub or another switch
For Gigabit Ethernet switches ONLY. When a port is a Private VLAN
Edge (PVE) port, it bypasses the Forwarding Database and forwards
all unicast, multicast, and broadcast traffic to an uplink. Uplinks can
be ports or LAGs.