Table of Contents
Advertisement
3 :
30
31
4 :
40
41
5 :
50
51
6 :
60
61
5.18 Radius Commands
5.18.1 radius-server host
The radius-server host global configuration command specifies a RADIUS server host. To delete the
specified
RADIUS host, use the no form of this command.
Syntax
radius-server host {ip-address} [auth-port auth-port-number] [timeout timeout] [retransmit retransmit]
[deadtime deadtime] [key key] [source source] [priority priority]
no radius-server host ip-address
ip-address — IP address of the RADIUS server host. An out-of-band IP address can be specified
as described in the usage guidelines.
timeout — Specifies the timeout value in seconds. If no timeout value is specified, the global
value is used. (Range: 1 - 30)
retransmit — Specifies the re-transmit value. If no re-transmit value is specified, the global value
is used. (Range: 1 -10)
deadtime — Length of time, in minutes, for which a RADIUS server is skipped over by transaction
requests. (Range 0 - 2000)
key — Specifies the authentication and encryption key for all RADIUS communications between
the router and the RADIUS server. This key must match the encryption used on the RADIUS
daemon. If no key value is specified, the global value is used.
source — Specifies the source IP address to use for the communication. If no retransmit value is
specified, the global value is used. 0.0.0.0 is interpreted as request to use the IP address of the
outgoing IP interface. An out-of-band IP address can be specified as described in the usage
guidelines.priority—Determines the order in which the servers are used, where 0 is the highest
priority (Range: 0 - 65535).
priority — Determines the order in which the servers are used, where 0 is the highest priority.
(Range: 0 - 65535)
Default Configuration
By default, no RADIUS host is specified.
32
33
34
35
36
42
43
44
45
46
52
53
54
55
56
62
63
37
38
39
47
48
49
57
58
59
Advertisement
Table of Contents
