Planet Networking & Communication WGSD-1022 User Manual page 68

The Page contains the following fields:
• Select QoS Mode
• Class of Service
• Queue
The Restore Defaults button restores the device factory defaults for mapping CoS values to a
forwarding queue.
802.1p Default:
The Table contains the following fields:
• Port#
• Default CoS
• Restore Defaults
• LAG
This indicates if QoS is enabled on the interface. The possible values
are:
• Disable, disables QoS on the interface.
• Port Qos, enables QoS on the interface.
• Policy Qos, enables the Advanced Mode QoS on the interface.
Specifies the CoS priority tag values, where zero is the lowest and 7
is the highest
Defines the traffic forwarding queue to which the CoS priority is
mapped.
Four traffic priority queues are supported
Interface to which the CoS configuration applies
Determines the default CoS value for incoming packets for which a
VLAN tag is not defined. The possible field values are 0-7.
The default CoS is 0
Restores the device factory defaults for mapping CoS values to
forwarding queue.
LAG to which the CoS configuration applies.