Table of Contents
Advertisement
User Guidelines
There are no user guidelines for this command.
Examples
The following example sets up the community access string "public" to permit administrative access to
SNMP protocol, at an administrative station with the IP address 192.168.1.20.
Console (config)# snmp-server community public su 192.168.1.20
The following examples set up the community access string "public" to permit read-write access to SNMP
protocol, using the out-of-band port for 192.175.1.10.
Console (config)# snmp-server community public rw 192.175.1.10 type oob
5.20.2 snmp-server contact
The snmp-server contact global configuration command sets up a system contact. To remove the
system contact information, use the no form of the command.
Syntax
snmp-server contact text
no snmp-server contact
text — Character string, up to 160 characters, describing the system contact information.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
Do not include spaces in the text string.
Example
The following example displays setting up the system contact point as "abc_Technical_Support".
Console (config)# snmp-server contact abc_Tecnical_Support
5.20.3 snmp-server location
The snmp-server location global configuration command sets up information on where the device is
located. To remove the location string use, the no form of this command.
Advertisement
Table of Contents
