Gvrp Enable (Interface) - Planet Networking & Communication WGSD-1022 User Manual

Default Configuration
GVRP is globally disabled.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example globally enables GVRP on the device.
Console (config)# gvrp enable

5.8.2 gvrp enable (interface)

The gvrp enable interface configuration command enables GVRP on an interface. To disable GVRP on
an interface, use the no form of this command.
Syntax
gvrp enable
no gvrp enable
Default Configuration
GVRP is disabled on all interfaces by default.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
An access port would not dynamically join a VLAN because it is always a member in only one VLAN.
Example
The following example enables GVRP on ethernet g8.
Console (config)# interface ethernet e8
Console (config-if)# gvrp enable