Port Security; Port Security Routed Secure-Address - Planet Networking & Communication WGSD-1022 User Manual

5.4.11 port security

The port security interface configuration command locks the port. By locking the port, new addresses
are not learned on the port. To enable new address learning, use the no form of the port security
command.
Syntax
port security [forward | discard | discard-shutdown] [trap seconds]
no port security
forward — Forwards frames with unlearned source addresses, but does not learn the address.
discard — Discards frames with unlearned source addresses. This is the default if no option is
indicated.
discard-shutdown — Discards frames with unlearned source addresses. The port is also shut
down.
trap Seconds — Sends SNMP traps and defines the minimal amount of time in seconds between
two consecutive traps. (Range: 1 - 1,000,000)
Default Configuration
Disabled - No port security
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
In this example, frame forwarding is enabled without learning, and with traps sent every 100 seconds on
port e18.
console (config)# interface ethernet e18
console (config-if)# port security forward trap 100

5.4.12 port security routed secure-address

The port security routed secure-address interface configuration command adds MAC-layer secure
addresses to a routed port. Use the no form of this command to delete the MAC addresses.