Port Config - Planet Networking & Communication WGSD-1022 User Manual

4.4.2 Port Config

In this port setting screen (refer to figure 4-12), the parameters managing ports that are part of a VLAN
will be provided, and you can set the default VLAN ID (PVID). All untagged packets arriving to the device
are tagged by the ports PVID.
The page contains the following fields:
• Port#
• Mode
• Acceptable Frame Type
• PVID
Figure 4-12 VLAN Port Setting screen
Displays the port number included in the VLAN
Indicates the port mode. Possible values are:
• General - The port belongs to VLANs, and each VLAN is
user-defined as tagged or untagged (full 802.1Q mode).
• Access - The port belongs to a single untagged VLAN. When a
port is in Access mode, the packet types which are accepted on the
port (packet type) cannot be designated. It is also not possible to
enable/ disable ingress filtering on an access port.
• Trunk - The port belongs to VLANs in which all ports are tagged
(except for an optional single native VLAN).
Packet type accepted on the port. Possible values are:
• Admit Tag Only - indicates that only tagged packets are accepted
on the port.
• Admit All - indicates that both tagged and untagged packets are
accepted on the port.
Assigns a VLAN ID to untagged packets. The possible values are 2 to
4094. VLAN 4095 is defined as per standard and industry practice as
the discard VLAN. Packets classified to the Discard VLAN are dropped