Bridge Multicast Address - Planet Networking & Communication WGSD-1022 User Manual

Syntax
bridge multicast filtering
no bridge multicast filtering
Default Configuration
Disabled. All multicast addresses are flooded to all ports of the relevant VLAN.
Command Mode
Global Configuration mode
User Guidelines
If multicast routers exist on the VLAN and IGMP-snooping is not enabled, the bridge multicast
forward-all command should be used to enable forwarding all multicast packets to the multicast routers.
Example
In this example, bridge multicast filtering is enabled.
console (config)# bridge multicast filtering

5.4.3 bridge multicast address

The bridge multicast address interface configuration command registers MAC-layer multicast
addresses to the bridge table, and adds static ports to the group. To unregister the MAC address, use the
no form of the bridge multicast address command.
Syntax
bridge multicast address {mac-multicast-address | ip-multicast-address}
bridge multicast address {mac-multicast-address | ip-multicast-address} [add | remove] {ethernet
interface-list | port-channel port-channel-number-list}
no bridge multicast address {mac-multicast-address | ip-multicast-address}
add — Adds ports to the group. If no option is specified, this is the default option.
remove — Removes ports from the group.
mac-multicast-address — MAC multicast address.
ip- multicast-address — IP multicast address.
interface-list — Separate nonconsecutive Ethernet ports with a comma and no spaces; a hyphen
is used to designate a range of ports.
port-channel-number-list — Separate nonconsecutive port-channels with a comma and no spaces;