Radius-Server Timeout - Planet Networking & Communication WGSD-1022 User Manual

Default Configuration
The default IP address is the outgoing IP interface.
Command Mode
Global Configuration mode
User Guidelines
To define an out-of-band IP address, use the out-of-band IP address format —oob/ip-address.
Example
The following example configures the source IP address used for communication with RADIUS servers to
10.1.1.1.
Console (config)# radius-server source-ip 10.1.1.1

5.18.5 radius-server timeout

The radius-server timeout global configuration command sets the interval for which a router waits for a
server host to reply. To restore the default, use the no form of this command.
Syntax
radius-server timeout timeout
no radius-server timeout
timeout — Specifies the timeout value in seconds. (Range: 1 - 30)
Default Configuration
The default value is 3 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets the interval for which a router waits for a server host to reply to 5 seconds.
Console (config)# radius-server timeout 5