Planet Networking & Communication WGSD-1022 User Manual page 90

Disabled ports are activated from the Port Security page.
• Port#
• Lock Interface
• Learning Mode
• Max Entries
• Action on Violation
• Enable Trap
• Trap Frequency
In order to change the Learning Mode, the Lock Interface must be set to unlocked.
Note
:
Once the mode is changed, the Lock Interface can be reinstated.
Where displays the port or LAG name
Which selecting this option locks the specified interface.
Where defines the locked port type. The Learning Mode field is
enabled only if Locked is selected in the Interface Status field. The
possible field values are:
• Classic Lock, by which locks the port using the classic lock
mechanism. The port is immediately locked,
regardless of the number of addresses that have already been
learned.
• Limited Dynamic Lock, which locks the port by deleting the
current dynamic MAC addresses associated with the port. The
port learns up to the maximum addresses allowed on the port.
Both relearning and aging MAC addresses are enabled.
Specifies the number of MAC addresses that can be learned on the
port. The Max Entries field is enabled only if Locked is selected in the
Interface Status field. In addition, the Limited Dynamic Lock mode is
selected.
The default is 1.
Where indicates the action to be applied to packets arriving on a
locked port. The possible field values are:
• Discard, which discards packets from any unlearned source.
This is the default value.
• Forward Normal, forwards packets from an unknown source
without learning the MAC address.
• Discard Disable, which discards packets from any unlearned
source and shuts down the port. The port remains shut down
until reactivated, or until the device is reset.
This enables traps when a packet is received on a locked port.
Which the amount of time (in seconds) between traps.
The default value is 10 seconds