Exec-Timeout - Planet Networking & Communication WGSD-1022 User Manual

User Guidelines
There are no user guidelines for this command, which is available only on the console line.
Examples
The following example the baud rate is set to 19200.
Console (config)# line console
Console(config-line)# speed 19200

5.12.3 exec-timeout

The exec-timeout line configuration command sets the interval that the system waits until user input is
detected. To restore the default setting, use the no form of this command.
Syntax
exec-timeout minutes [seconds]
no exec-timeout
minutes — Integer that specifies the number of minutes. (Range: 0 - 65535)
seconds — Additional time intervals in seconds. (Range: 0 - 59)
Default Configuration
The default configuration is 10 minutes.
Command Mode
Line Configuration mode
User Guidelines
To specify no timeout, enter the exec-timeout 0 command.
Examples
The following example configures the interval that the system waits until user input is detected to 20
minutes.
Console (config)# line console
Console(config-line)# exec-timeout 20