Snmp-Server Trap Authentication; Snmp-Server Host - Planet Networking & Communication WGSD-1022 User Manual

5.20.5 snmp-server trap authentication

The snmp-server trap authentication global configuration command enables the switch to send Simple
Network Management Protocol traps when authentication fails. To disable SNMP authentication failed
traps, use the no form of this command.
Syntax
snmp-server trap authentication
no snmp-server trap authentication
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Examples
The following example displays the command to enable authentication failed SNMP traps.
Console (config)# snmp-server trap authentication
Console (config)# snmp-server host 10.1.1.1 management 2

5.20.6 snmp-server host

The snmp-server host global configuration command specifies the recipient of Simple Network
Management Protocol notification operation. To remove the specified host, use the no form of this
command.
Syntax
snmp-server host host-addr community-string [1 | 2]
no snmp-server host host-addr
host-address — Internet address of the host (the targeted recipient). An out-of-band IP address
can be specified as described in the User Guidelines.
community-string — Password-like community string sent with the notification operation. (R ange:
1 - 20 characters)
1 — SNMPv1 traps is used.
2 — SNMPv2 traps is used (Default).