Qos Cos - Planet Networking & Communication WGSD-1022 User Manual

Default Configuration
Each port is enabled while the system is in basic mode.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
Use no qos trust to disable the trust mode on each port.
Use qos trust to enable trust mode on each port.
Example
The following example configures port e5 in basic mode to default trust state (CoS).
Console (config)# interface ethernet e5
Console (config-if) qos trust

5.17.10 qos cos

The qos cos interface configuration command configures the default port CoS value. To return to the
default setting, use the no form of this command.
Syntax
qos cos default-cos
no qos cos
qos cos override
default-cos — Specifies the default CoS value being assigned to the port. If the port is trusted and
the packet is untagged then the default CoS value becomes the CoS value. (Range: 0 - 7)
Default Configuration
Port CoS is 0.
Command Mode
Interface Configuration (Ethernet, port-channel) command
User Guidelines
There are no user guidelines for this command.
Example
The following example configures port e5 default CoS value to 3.
Console (config)# interface ethernet e5
Console (config-if) qos cos 3