Planet Networking & Communication WGSD-1022 User Manual page 38

• Duplex Mode
• MDI/ MDIX
• Flow control
• Phy Type
• LAG
• PVE
• Edit
configured only when auto-negotiation is disabled on that port
The port duplex mode, Full (transmission occurs in both directions
simultaneously) or Half (transmission occurs in only one direction at a
time). This mode can be configured only when auto-negotiation is
disabled and port speed is set to 10Mbps or 100Mbps.
It cannot be configured on Link Aggregation Groups (LAGs)
Shows the MDI/MDIX status of the port. To use the MDI setting if the
port is connected to an end station. To use the MDIX setting if the port
is connected to a hub or another switch
Shows the flow control status of the port. It is active when the port
uses Full Duplex Mode
Shows the port type
Shows whether the port is part of a LAG
It bypasses the Forwarding Database and forwards all unicast,
multicast, and broadcast traffic to an uplink when a port is a Private
VLAN Edge (PVE) port, Uplinks can be ports or LAGs
It will open the port configuration detail screen