Dot1X Timeout Quiet-Period; Dot1X Timeout Tx-Period - Planet Networking & Communication WGSD-1022 User Manual

5.29.7 dot1x timeout quiet-period

The dot1x timeout quiet-period interface configuration command sets the number of seconds that the
switch remains in the quiet state following a failed authentication exchange (for example, the client
provided an invalid password). Use the no form of this command to return to the default setting.
Syntax
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
seconds — Time in seconds that the switch remains in the quiet state following a failed
authentication exchange with the client. (Range: 0 - 65535 seconds)
Default Configuration
60
Command Mode
Interface configuration (Ethernet)
User Guidelines
During the quiet period, the switch does not accept or initiate any authentication requests.
The default value of this command should only be changed to adjust for unusual circumstances, such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
If it is necessary to provide a faster response time to the user, a smaller number than the default should
be entered.
Examples
The following example sets the number of seconds that the switch remains in the quiet state following a
failed authentication exchange, to 3600.
Console (config)# interface ethernet e8
Console (config-if)# dot1x timeout quiet-period 3600

5.29.8 dot1x timeout tx-period

The dot1x timeout tx-period interface configuration command sets the number of seconds that the
switch waits for a response to an Extensible Authentication Protocol (EAP) - request/identity frame, from
the client, before resending the request. Use the no form of this command to return to the default setting.
Syntax
dot1x timeout tx-period seconds