Ip Config - Planet Networking & Communication WGSD-1022 User Manual

4.2.2 IP Config

The Basic Setup Table include the IP Config (see figure 4-4), which allows you to assign DHCP or static
IP settings to interfaces and assign default gateways. In the IP Config screen, you can set these parts as
below:
The page includes the following fields:
• System Name
• System Location
• System Contact
• Management VLAN
• IP Setting Mode
• Host Name
• IP Address
• Subnet Mask
Figure 4-4 IP Config screen
Type your system name
Type where the Switch is located
Enter the administrative contact person
Where you can select the Management VLAN.
The default Managemanet VLAN is VLAN 1
Where select Static or Dynamic IP address configuration.
The Default Mode is Static
In this field you can enter the DHCP Host Name
Enter the IP address when you want to use a static address.
The default IP Address is 192.168.1.254
Enter the IP subnet mask for the interface.
The factory default value is 255.255.255.0