Show Interfaces Status - Planet Networking & Communication WGSD-1022 User Manual

5.7.15 show interfaces status

The show interfaces status user EXEC command displays the status for all configured interfaces.
Syntax
show interfaces status [ethernet interface | port-channel port-channel-number | out-of-band-eth
oob-interface]
Interface — A valid Ethernet port.
port-channel-number — A valid port-channel trunk index.
oob-interface — Out of band Ethernet port number.
Default Configuration
This command has no default configuration.
Command Mode
Privilege EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the status for all configured interfaces.
Console# show interfaces status
Port Type Duplex
----- -------- ------------ ----------- ------------
e1 100 Full
e1 100 Full
e2 100 Full
Ch Type Duplex
------- -------- -----------
1 1000 Full
The displayed port status information includes the following:
Port—The port number.
Description—If the port has a description, the description is displayed.
Port Type—The port designated IEEE shorthand identifier. For example, 1000Base-T refers to
1000 Mbps baseband signaling inluding both Tx and Rx transmissions.
Duplex—Displays the port Duplex status.
Speed Neg Flow
Control
----------- ----------
100 Auto On
100 Off Off
100 Off Off
Speed Neg Flow
Control
----------- --------- -------------
1000 Off Off
Link Back
State Pressure
------------ -----------
Up Enable
Down Disable
Up Disable
Back Link
Pressure State
-------------- ---------
Disable Up
Mdix
Mode
On
Off
On