Table of Contents
Advertisement
The WGSD-1022 is a managed Ethernet Switch that can be controlled by the RS-232 console interface,
telnet interface, and Web interface. This chapter describer how to configure the Switch through these
interfaces.
When you are ready to configure the smart functions of the Switch, make sure you had connected the
supplied RS-232 serial cable to the RS-232 port at the front panel of your WGSW-24010 Switch and your
PC.
5.1 Connect to PC's RS-232 serial port
Hyper Terminal
In Windows 98/2000/XP, launch "HyperTerminal", create a new connection, and adjust settings as below:
Baud per second: 38400
Data bits: 8
Parity: None
Stop bits: 1
Flow Control: None
5. COMMAND STRUCTURE
Advertisement
Table of Contents
