Table of Contents
Advertisement
User Guidelines
There are no user guidelines for this command.
Example
The following example sets a protocol-based classification rule of protocol group 1 to VLAN 8.
Console (config)# interface ethernet e8
Console (config-if)# switchport general map protocols-group 1 vlan 8
5.27.18 ip internal-usage-vlan
The ip internal-usage-vlan interface configuration command reserves a VLAN as the internal usage
VLAN of an interface. Use the no form of this command to reset to default.
Syntax
ip internal-usage-vlan vlan-id
no ip internal-usage-vlan
vlan-id — VLAN ID of the internal usage VLAN.(Range: Valid VLAN)
Default Configuration
This command has no default configuration.
Command Mode
Interface configuration (Ethernet, port-channel)
User Guidelines
An internal usage VLAN is required when an IP interface is defined on Ethernet port or Port-channel.
Using this command the user can define the internal usage VLAN of a port.
If an internal-usage is not defined for a Port, and the user wants to define an IP interface, the software
chooses one of the unused VLANs.
If a VLAN ID was chosen by the software for internal usage, and the user wants to use that VLAN ID for
static or dynamic VLAN, he should either remove the IP interface, creates the VLAN, and recreate the IP
interface, or use this command to define explicit internal usage VLAN.
Examples
The following example reserves a VLAN as the internal usage VLAN of an interface..
Console (config)# ip internal-usage-vlan 10
Advertisement
Table of Contents
