Priority-Queue Out Num-Of-Queues - Planet Networking & Communication WGSD-1022 User Manual

weight is ignored (not used in the ratio calculation). The expedite queue is a priority queue, and it is
serviced until empty before the other queues are serviced.
Use the priority-queue out num-of-queues command to globally configure a queue as WRR or Strict
Priority.
Use this command to set a weight per interface.
Example
The following example sets queue weights as follows:
Queue 1—6/36
Queue 2—6/36
Queue 3—6/36
Queue 4—6/36
Queue 5—6/36
Queue 6—6/36
Queue 7—6/36
Queue 8—6/36
Console (config-if)# wrr-queue bandwidth 6 6 6 6 6 6 6 6

5.17.5 priority-queue out num-of-queues

The priority-queue out num-of-queues global configuration command enables the egress queues to be
expedite queues. Use the no form of this command to return to the default values.
Syntax
priority-queue out num-of-queues number-of-queues
no priority-queue out num-of-queues
number-of-queues — Assign the number of queues to be expedite queues. The expedite queues
would be the queues with higher indexes. The range is 1 – 8.
Default Configuration
All queues are expedite queues.
Command Mode
Global Configuration mode
User Guidelines
When configuring the priority-queue out num-of-queues command, the weighted round robin (WRR)
weight ratios are affected because there are fewer queues participating in WRR.