D-Link xStack DES-3528 Series Cli Reference Manual page 38

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
disable port_security trap_log
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the port security trap log setting:
DES-3528:admin# disable port_security trap_log
Command: disable port_security trap_log
Success.
DES-3528:admin#
config port_security system max_learning_addr
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the maximum number of port security entries on the Switch to be 256:
DES-3528:admin# config port_security system max_learning_addr 256
Command: config port_security system max_learning_addr 256
Success.
DES-3528:admin#
Used to disable the trap log for port security.
disable port_security trap_log
This command, along with the enable port_security trap_log, will enable and disable the
sending of log messages to the Switch's log and SNMP agent when the port security of the
Switch has been triggered.
None.
Only Administrator and Operator-level users can issue this command.
This command sets the maximum number of port security entries that can be authorized
system wide.
config port_security system max_learning_addr [<max_lock_no 1-16384> | no_limit]
There are four levels of limitations on the learned entry number; for the entire system, for a
port, for a VLAN, and for a specific VLAN on a port. If any limitation is exceeded, the new
entry will be discarded.
The setting for system level maximum learned users must be greater than the total of
maximum learned users allowed on all ports.
max_learning_addr - Specifies the maximum number of port security entries that can be
learned by the system. If the setting is smaller than the number of current learned entries on
all enabled ports, the command will be rejected.
<max_lock_no 1-16384> - Enter the maximum learning address value here. This value must
be between 1 and 16384.
no_limit - No limitation on the number of port security entries that can be learned by the
system. By default, the number is set to no_limit.
Only Administrator and Operator-level users can issue this command.
38