D-Link xStack DES-3528 Series Cli Reference Manual page 531

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
debug dhcpv6_relay output
Purpose
Used to set debug message to output to buffer or console.
Syntax debug dhcpv6_relay output [buffer | console]
Description Used to set debug message to output to buffer or console.
Parameters output - Specifies the location of the debug message output.
buffer - Let the debug message output to buffer.
console - Let the debug message output to console.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To set debug information to output to console:
DES-3528:admin#
Command: debug dhcpv6_relay output console
Success.
DES-3528:admin#
debug dhcpv6_relay packet
Purpose
Used to enable or disable debug information flag for DHCPv6 relay packet, including packet
receiving and sending.
Syntax debug dhcpv6_relay packet {all | receiving | sending} state [enable | disable]
Description Used to enable or disable debug information flag for DHCPv6 relay packet, including packet
receiving and sending.
Parameters all - (Optional) Set packet receiving and sending debug flags.
receiving - (Optional) Set packet receiving debug flag.
sending - (Optional) Set packet sending debug flag.
state - Specifies if the designated flags function will be enabled or disabled.
enable - Enable the designated flags.
disable - Disable the designated flags.
Restrictions Only Administrator, Operator and Power User-level users can issue this command.
Example usage:
To enabled DHCPv6 relay packet sending debug:
DES-3528:admin#
Command: debug dhcpv6_relay packet sending state enable
Success.
DES-3528:admin#
debug dhcpv6_relay hop_count state
Purpose This command is used to enable or disable debug information flag about the hop count.
Syntax debug dhcpv6_relay hop_count state [enable | disable]
Description This command is used to enable or disable debug information flag about the hop count.
Parameters enable - Enable debug dhcpv6_relay hop_count state.
disable - Disable debug dhcpv6_relay hop_count state.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To enable debug information flag about the hop count:
debug dhcpv6_relay output console
debug dhcpv6_relay packet sending state enable
531