D-Link xStack DES-3528 Series Cli Reference Manual page 201

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
config igmp_snooping rate_limit
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the IGMP snooping per port rate_limit:
DES-3528:admin#
Command: config igmp_snooping rate_limit ports 1 100
Success.
DES-3528:admin#
The command configures the rate of IGMP control packet that is allowed per port or per
VLAN.
config igmp_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-
1000> | no_limit]
The command configures the rate of IGMP control packet that is allowed per port or per
VLAN.
ports - Specify a range of ports to be configured.
<portlist> - Enter the range of ports to be configured here.
vlanid - Specify a range of VLANs to be configured.
<vlanid_list> - Enter the VLAN ID list here.
<value 1-1000> - Configure the rate of the IGMP control packet that the Switch can process
on a specific port/VLAN. The rate is specified in packets per second. The packets that
exceed the limit will be dropped.
no_limit - Configure the rate of the IGMP control packet to be unlimited that the Switch can
process on a specific port/VLAN. The rate is specified in packets per second. The packets
that exceed the limit will be dropped. The default setting is no_limit.
Only Administrator and Operator and Power-User-level users can issue this command.
config igmp_snooping rate_limit ports 1 100
201