D-Link xStack DES-3528 Series Cli Reference Manual page 382

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
Q-Srv Error Timeout
RADIUS Auth-Protocol
Authentication Failover : Disabled
RADIUS Authorization
Local Authorization
Update Server
DES-3528:admin#
show jwac auth_state ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display a JWAC host.
DES-3528:admin# show jwac auth_state ports 5
Command: show jwac auth_state ports 5
Port MAC Address
----- -------------------- -------------- ------- -------- ----------- ---------
5 00-00-00-00-00-04
Total Authenticating Hosts
Total Authenticated Hosts
Total Blocked Hosts
DES-3528:admin#
: 30 Seconds
: PAP
: Enabled
: Enabled
:172.18.202.1/32
172.18.202.0/24
10.1.1.0/24
Used to display information of JWAC client host
show jwac auth_state ports {<portlist>}
This command allows you to show the information of JWAC client host.
If port 1 is in host-based mode:
(1) MAC 00-00-00-00-00-01 is authenticated without VLAN assigned (may be the specified
target VLAN does not exist or the target VLAN has not been specified), the ID of RX VLAN
will be displayed (RX VLAN ID is 4004 in this example).
(2) MAC 00-00-00-00-00-02 is authenticated with target VLAN assigned, the ID of target
VLAN will be displayed (target VLAN ID is 1234 in this example)
(3) MAC 00-00-00-00-00-03 failed to pass authentication, the VID field will be shown as "-"
indicating that packets with SA 00-00-00-00-00-03 will be droped no matter which VLAN
these packets are from.
(4) MAC 00-00-00-00-00-04 attempts to start authentication, the VID field will be shown as "-"
until authentication completed.
If port 2 is in port-based mode:
(1) MAC 00-00-00-00-00-10 is the mac which made port 2 pass authentication, mac address
with "(P)" in the end indicats that this authentication is from a port in port-based mode.
If port 3 is in port-based mode:
(1) MAC 00-00-00-00-00-20 attempts to start authentication, mac address with "(P)" in the
end indicats the port-based mode authentication.
(2) MAC 00-00-00-00-00-21 failed to pass authentication, mac address with "(P)" in the end
indicats the port-based mode authentication.
NOTE : In port-based mode, the VLAN ID field is displayed in the same way as host-based
mode
port – A port range to show the information of client host.
None.
State
Authenticating -
: 1
: 0
: 0
VLAN ID Assigned Aging Time/ Idle Time
Priority Block Time
-
382
4 -