D-Link xStack DES-3528 Series Cli Reference Manual page 224

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
config mld_snooping static_group
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To unset port range 9-10 from MLD snooping static member ports for group FF1E::1 on default VLAN:
DES-3528:admin#
Command: create mld_snooping static_group vlan default FF1E::1 delete 2:9-2:10
Success.
DES-3528:admin#
show mld_snooping static_group
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display all the MLD snooping static groups:
DES-3528:admin#
VLAN ID/Name
--------------
1 / default
Total Entries : 1
DES-3528:admin#
Used to configure an MLD snooping multicast group static member port.
config mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>]
<ipv6addr> [add | delete] <portlist>
When a port is configured as a static member port, the MLD protocol will not operate on this
port. For example, suppose that a port is a dynamic member port learned by MLD. If this port
is configured as a static member later, then the MLD protocol will stop operating on this port.
The MLD protocol will resume once this port is removed from static member ports. The static
member port will only affect MLD V1 operation.
vlan - Specify the name of the VLAN on which the static group resides.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specify the ID of the VLAN on which the static group resides.
<vlanid_list> - Enter the VLAN ID list here.
<ipv6addr> - Specify the multicast group IPv6 address.
add - Specify to add the member ports.
delete - Specify to delete the member ports.
<portlist> - Specify a range of ports to be configured.
Only Administrator and Operator and Power-User-level users can issue this command.
config mld_snooping static_group vlan default FF1E::1 delete 2:9-2:10
This command used to display the MLD snooping multicast group static members.
show mld_snooping static_group {[vlan <vlan_name 32> | vlanid <vlanid_list>]
<ipv6addr>}
This command used to display the MLD snooping multicast group static members.
vlan - (Optional) Specify the name of the VLAN on which the static group resides.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - (Optional) Specify the ID of the VLAN on which the static group resides.
<vlanid_list> - Enter the VLAN ID list here.
<ipv6addr> - (Optional) Specify the multicast group IPv6 address.
None.
show mld_snooping static_group
IP Address
------------------
FF1E ::1
Static Member Ports
------------------------
2:9-2:10
224