Ethernet Ring Protection Switching (Erps) Commands - D-Link xStack DES-3528 Series Cli Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
Ethernet Ring Protection Switching (ERPS)
Commands
The Ethernet Ring Protection Switching (ERPS) commands in the Command Line Interface (CLI) are listed (along with
the appropriate parameters) in the following table.
Command
enable erps
disable erps
create erps raps_vlan
delete erps raps_vlan
config erps raps_vlan
config erps raps_vlan
config erps raps_vlan
config erps raps_vlan
config erps raps_vlan
config erps raps_vlan
config erps log
show erps
config erps trap
config erps raps_vlan
config erps raps_vlan
config erps raps_vlan
Each command is listed, in detail, in the following sections.
enable erps
Purpose This command is used to enable the global ERPS function on a Switch.
Syntax enable erps
Description
When both the global state and the specified ring ERPS state are enabled, the specified ring
will be activated.
The global ERPS function cannot be enabled, when any ERPS ring on the device is enabled
and the integrity of any ring parameter is not available. For each ring with the ring state
enabled when ERPS is enabled, the following integrity will be checked:
1.
2.
3.
Parameters None.
Restrictions Only Administrator, Operator and Power User-level users can issue this command.
Example usage:
To enable ERPS:
Parameters
<vlanid>
<vlanid>
<vlanid> ring_mel <value 0-7>
<vlanid> ring_port [west [<port> | virtual_channel] | east [<port> |
virtual_channel]]
<vlanid> rpl_port [west | east | none]
<vlanid> rpl_owner [enable | disable]
<vlanid> protected_vlan [add | delete] vlanid <vidlist>
<vlanid> timer {holdoff_time <millisecond 0-10000> | guard_time <millisecond
10-2000 > | wtr_time <min 5-12>}(1)
[enable | disable]
{raps_vlan <vlanid> {sub_ring}}
[enable | disable]
<vlanid> state [enable | disable]
<vlanid> [add | delete] sub_ring raps_vlan <vlanid>
<vlanid> sub_ring raps_vlan <vlanid> tc_propagation state [enable | disable]
R-APS VLAN is created.
The Ring port is a tagged member port of the R-APS VLAN.
The RPL port is specified if the RPL owner is enabled.
535