D-Link xStack DES-3528 Series Cli Reference Manual page 374

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
DES-3528:admin# config jwac quarantine_server_error_timeout 60
Command: config jwac quarantine_server_error_timeout 60
Success.
DES-3528:admin#
config jwac redirect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure JWAC redirect:
DES-3528:admin# config jwac redirect destination jwac_login_page delay_time 5
Command: config jwac redirect_ destination jwac_login_page delay_time 5
Success.
DES-3528:admin#
config jwac virtual_ip
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure JWAC virtual IP:
DES-3528:admin# config jwac virtual_ip 1.1.1.1
Command: config jwac virtual_ip 1.1.1.1
Success.
DES-3528:admin#
Used to configure redirect destination and delay time before an unauthenticated host is
redirected to the Quarantine Server or the JWAC login web page.
config jwac redirect {destination [quarantine_server | jwac_login_page] | delay_time
<value 0-10>}(1)
This command allows you to configure redirect destination and delay time before an
unauthenticated host is redirected to the Quarantine Server or the JWAC login web page.
The unit of delay time is seconds.
0 means no delaying the redirect.
destination − To specify the destination which the unauthenticated host will be redirected to.
delay_time − To specify the time interval after which the unauthenticated host will be
redirected.
Only Administrator and Operator and Power-User-level users can issue this command.
Used to configure JWAC virtual IPaddress used to accept authentication requests from an
unauthenticated host.
config jwac virtual_ip <ipaddr> {url [<string 128> | clear]}
The virtual IP of JWAC is used to accept authentication requests from unauthenticated hosts.
Only requests sent to this IP will get a correct response. This IP does not respond to ARP
requests or ICMP packets! Do not set this IP as the same subnet of the client PC and do not
set its IP to the same as another device, otherwise the client PC cannot access the device.
<ipaddr> − To specify the IP address of the virtual IP.
url – Specifies the JWAC virtual IP URL used.
<string 128> - Enter the JWAC virtual IP URL used here. This value can be up to 128
characters long.
clear – Specifies that the JWAC virtual IP will be cleared.
Only Administrator and Operator and Power-User-level users can issue this command.
374