D-Link xStack DES-3528 Series Cli Reference Manual page 41

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
DES-3528:admin#
show stack_information
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To display stack information:
DES-3528:admin#
Command: show stack_information
Topology :Duplex_Chain
My Box ID :1
Master ID :1
Box Count :1
Force Master Role: Disabled
Box User
ID Set Type
--- ---- ------------- ----- ---- ----------------- --------- --------- --------
1 Auto DES-3528
2 - NOT_EXIST
3 - NOT_EXIST
4 - NOT_EXIST
5 - NOT_EXIST
6 - NOT_EXIST
7 - NOT_EXIST
8 - NOT_EXIST
DES-3528:admin#
config stacking_mode
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To disable the stacking mode:
DES-3528:admin# config stacking_mode disable
Command: config stacking_mode disable
Change Box bootmode may cause devices work restart, still continue? (y/n)y
Used to display the stack information table.
show stack_information
This command display stack information.
None.
Only Administrator and Operator and Power-User-level users can issue this command.
show stack_information
Prio-
Exist rity
Exist 32 00-22-B0-10-8A-00 1.00.B008 3.00.012 A2
No
No
No
No
No
No
No
Used to configure the stacking mode.
config stacking_mode [disable(0) | enable(1)]
This command will enable or disable the stacking mode for the Switch. When enabled,
the last two ports on the rear of the Switch will be enabled for stacking.
enable | disable – Use these parameters to enable or disable the stacking mode for the
Switch. Once this command is executed, it will cause the Switch to reboot. Before
configuring the stacking mode of a Switch to disable status, the Switch must be
physically removed from the stacking switches.
Only Administrator-level users can issue this command.
Prom
MAC version
41
Runtime H/W
version version