D-Link xStack DES-3528 Series Cli Reference Manual page 143

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
config voice_vlan aging_time
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set 60 minutes as the aging time of voice VLAN:
DES-3528:admin#
Command: config voice_vlan aging_time 60
Success.
DES-3528:admin#
config voice_vlan log state
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable log state of voice VLAN:
DES-3528:admin#config voice_vlan log state enable
Command: config voice_vlan log state enable
Success.
DES-3528:admin#
show voice_vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the voice VLAN global information when voice VLAN is enabled:
DES-3528:admin# show voice_vlan
Used to config voice VLAN aging time.
config voice_vlan aging_time <min 1-65535>
This command is used to set the aging time of the voice VLAN. The aging time is used to
remove a port from voice VLAN if the port is an dynamic VLAN member. When the last voice
device stops sending traffic and the MAC address of this voice device is aged out, the voice
VLAN aging timer will be started.The port will be removed from the voice VLAN after the
voice VLAN timer expires. If the voice traffic resumes before the aging timer expires, the
aging timer will be reset.
aging_time – Specifies the aging time. It ranges from 1 to 65535.
Only Administrator and Operator and Power-User-level users can issue this command.
config voice_vlan aging_time 60
Used to configure the log state for voice VLAN.
config voice_vlan log state [enable | disable]
This command is used to configure the log state for voice VLAN. If there is a new voice
device detected/ or a port join/leave the voice VLAN dynamically, and the log is enabled, a
log will be triggered.
enable – Specifies to enable sending the issue of voice VLAN log.
disable - Specifies to disable sending the issue of voice VLAN log.
Only Administrator and Operator and Power-User-level users can issue this command.
Used to display voice VLAN global information.
show voice_vlan
This command is used to display voice VLAN global information.
None.
None.
143